MIL --- PRF --- 51200D
6. Place the sample bag in an larger plastic bag and seal after all soil samples
are in the bag.
7.Discard the gloves, scoop and other equipment.
Surface Sampling Procedures
1. Locate and prepare your sampling target area and sample documentation.
2. Don gloves and open a packet of containers containing wipes.
3. Open container and grasp wipe with self- locking tweezers. Softly scrub the targeted surface. Place the wipe back
in the container. Discard tweezers.
4. Screw the cap on tightly. Place the sample container in a sealable plastic bag provided. Write identification in-
formation on custody seal and apply custody seal over a rolled end section of the plastic bag.
5. Place the sample bag in an larger plastic bag and seal after all surface samples are in the bag.
Liquid Sampling Procedures
1. Fill in the documentation and custody form.
2. Don gloves and open bag of jars and a bag containing the extension tube and syringe.
3. Place the extension tube on the end of the syringe.
4. To collect sample, gently pull the handle of the syringe until the syringe is full of liquid.
5. Empty the water from the syringe into a container. Repeat procedure until container is filled to 75% of its vol-
ume.
6. Screw the cap on tightly. Secure the sample container in a sealable plastic bag provided. Write identification
information on custody seal and apply custody seal over a rolled end section of the plastic bag.
7. Place the sample bag in a larger plastic bag and seal after all liquid samples are in the bag.
3.3.16 Radioactive warning label. Each radioactive warning label shall be adhesive --- backed
and water --- proof. The area of the label shall be a maximum of no greater than 12 square inch-
es. An operator wearing MOPP IV gloves and overgloves shall be capable of removing the label
from its adhesive backing.
3.3.17 Cleaning of internal components. Any packaged components internal to the kit shall
be cleaned or free of contaminants prior to packaging.
3.3.18 Instructions for use. Detailed instructions shall be prepared as part of the kit and
used as a training aide. The example detailed instructions in Appendix A are based on the parts
list in Table V. The detailed instructions in Appendix A may be altered to reflect the actual
components selected for the kit. Illustrations may be used to support any of the steps in the
instructions. A parts list shall be included in the instructions. Instructions shall be prepared in
a booklet form. The dimensions of the booklet shall be 5.75±0.125 inches wide by 4.50±0.125
inches high. The pages and cover shall be securely fastened (e.g stapled) together. The front
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business